Declaration Of Conformity; C Leaning And Maintenance; Cleaning Agents - Gaggenau AW 25 Instrucciones De Uso Y Montaje

Declaration of Conformity

Gaggenau Hausgeräte GmbH hereby declares that the
appliance which features Home Connect is in
accordance with the basic requirements and the other
relevant provisions of the directive 2014/53/EU.
A detailed RED Declaration of Conformity can be found
online at www.gaggenau.com on the product page for
appliance in the additional documents.

C leaning and maintenance

2
m
Warning – Risk of burns!
C l e a n i n g a n d m a i n t e n a n c e
The appliance becomes hot during operation. Allow the
appliance to cool down before cleaning.
m
Warning – Risk of electric shock!
Penetrating moisture may result in an electric shock.
Clean the appliance using a damp cloth only. Before
cleaning, pull out the mains plug or switch off the circuit
breaker in the fuse box.
m
Warning – Risk of electric shock!
Do not use any high-pressure cleaners or steam
cleaners, which can result in an electric shock.
m
Warning – Risk of injury!
Components inside the appliance may have sharp
edges. Wear protective gloves.
m
Warning – Risk of injury!
Risk of trapping body parts when opening and closing
the glass front. Do not reach into the area behind the
glass panel, and keep your fingers away from the
hinges.
Cleaning and maintenance

Cleaning agents

To ensure that the different surfaces are not damaged
by using the wrong cleaning product, follow the
instructions in the table. Do not use any of the following:
▯
Harsh or abrasive cleaning agents, e.g. scouring
powder or liquid scouring cleaner,
▯
Cleaning products with a high alcohol content,
▯
Hard scouring pads or cleaning sponges,
▯
Pressure washers or steam cleaners,
▯
Cleaning products that dissolve limescale,
▯
Aggressive all-purpose cleaning products,
▯
Oven spray.
Note: Wash new sponge cloths thoroughly before use.
Note: Follow all instructions and warnings included with
the cleaning products.
Area Cleaning products
Stainless steel Hot soapy water:
Clean with a dish cloth and then dry with
a soft cloth.
Clean stainless steel surfaces in the
direction of the grain only.
Special stainless steel cleaning prod-
ucts are available from our after-sales
service or from specialist retailers.Apply
a very thin layer of the cleaning product
with a soft cloth.
Painted surfaces Hot soapy water:
Clean using a damp dish cloth and then
dry with a soft cloth.
Do not use stainless steel cleaner.
Aluminium and Hot soapy water:
plastic Clean with a soft cloth.
Glass Glass cleaner:
Clean with a soft cloth. Do not use a
glass scraper.
Controls Hot soapy water:
Clean using a damp dish cloth and then
dry with a soft cloth.
Risk of electric shock caused by pene-
trating moisture.
Risk of damage to the electronics
caused by penetrating moisture. Never
clean controls with a wet cloth.
Do not use stainless steel cleaner.
--------
en
13