Sensor Control; Saturation Display; Indirect Led Lighting; Lighting - Gaggenau AW 25 Instrucciones De Uso Y Montaje

Sensor control

In automatic mode, the sensor in the extractor hood
detects the intensity of the cooking and roasting
odours. Depending on the sensor setting, the fan
automatically switches itself to another fan setting.
Possible sensor settings:
Default sensitivity setting: 3 (fan setting 3)
Lowest sensitivity setting: 1 (fan setting 1)
Highest sensitivity setting: 4 (fan setting
If the sensor controller responds too strongly or not
enough, it can be changed accordingly:
1 Touch and hold the
switched off. The setting is displayed.
2 The sensor controller setting can be changed by
touching symbols 1, 2, 3, or
3 Touch and hold the

Saturation display

If the metal grease filters or activated charcoal filter
are/is saturated, the corresponding symbols will flash
once the appliance has been switched off:
▯
Metal grease filters:
▯
Activated charcoal filter:
▯
Regenerative activated charcoal filter:
If you have not yet done so, the metal grease filters
should now be cleaned or the activated charcoal filter
"Cleaning and maintenance" on page 13
replaced. ~
The saturation indicators can be reset while they are
flashing. To do this, press and hold the
œ
If the symbol lights up while the appliance is
switched off, you can query which filter is saturated. To
œ
do this, touch the symbol. The corresponding
symbols (1, 2, 3) will flash.
Switching over the display for air recirculation mode
For air recirculation mode, the electronic controller
must be switched over accordingly:
▯
The extractor hood must be connected and
switched off.
▯
Touch and hold the
"2" symbol.Touch and hold the
confirm. This will switch the electronic controller
over to air recirculation mode (filters that cannot be
regenerated).
▯
Touch and hold the
"3" symbol.Touch and hold the
confirm. This will switch the electronic controller
over to air recirculation mode (filters that can be
regenerated).
Ò
)
r
symbol when the fan is
Ò
.
r
symbol to confirm.
œ
and 1
œ
and 2
œ
œ
symbol.
œ
symbol. Touch the
œ
symbol to
œ
symbol. Touch the
œ
symbol to
▯
Touch and hold the
"1" symbol. This will switch the electronic controller
back to air extraction mode.
▯
Press and hold the

Indirect LED lighting

The indirect LED lighting can be switched on and off
independently of the fan.
j
Touch the
Setting the brightness
Press and hold the
brightness is reached.

Lighting

The lighting can be switched on and off independently
of the fan.
ž
Touch the
Setting the brightness
Press and hold the
brightness is reached.

Audible signal

and 3
Switching on
To go to the settings mode for the signal tone, touch
and hold the
approximately 3 seconds when the fan is switched off.
Touch the "1" symbol. Touching and holding the
Ò
symbols again will save the setting. An audible
signal will sound as an acknowledgement.
Switching off
To go to the settings mode for the signal tone, touch
and hold the
approximately 3 seconds when the fan is switched off.
Touch the "2" symbol. Touching and holding the
Ò
symbols again will save the setting.
Operating the appliance
œ
symbol again. Touch the
œ
symbol to save.
symbol.
j
symbol until the required
symbol.
ž
symbol until the required
# Ò
and symbols at the same time for
# Ò
and symbols at the same time for
en
#
and
#
and
9