Intensive Setting; Automatic Mode; Sensor Control; Saturation Display - Gaggenau AW 442 Instrucciones De Uso

Intensive setting

You can use the intensive setting if there is a large build-
up of odours and fumes/vapours.
Switching on
#
1 Press the button.
The fan starts at setting 2.
Ž
2 Press the button.
Intensive mode is activated.
Note: Intensive mode runs for six minutes. Once
this time has elapsed, the appliance switches back
to the previously selected fan setting.
Switching off
#
Press the button or the button for another fan
setting.
Intensive mode is deactivated.

Automatic mode

Switching on
#
1 Press the button.
The fan starts in fan setting 2.
<
2 Press the button.
The optimum fan setting 1, 2 or 3 is set
automatically by a sensor.
Switching off
< #
Press the or button.
Automatic mode is switched off.
The fan switches off automatically if the air quality in the
room exceeds a certain level. Automatic mode can run
for a maximum of four hours.

Sensor control

In automatic mode, a sensor in the extractor hood
detects the intensity of the cooking and roasting fumes.
Depending on the setting of the sensor, the fan
automatically switches to another fan speed.
Default sensitivity setting: 2
Lowest sensitivity setting: 1
Highest sensitivity setting: 4
8
Changing the sensitivity of the sensor
If the sensor control reacts too quickly or too slowly,
change the sensitivity setting.
1 When the fan is switched off, press and hold the
button for approx. 4 seconds.
The setting is displayed.
2 Press button 1, 2, 3 or the
sensitivity setting.
Button 1 = Sensitivity 1
Button 2 = Sensitivity 2
Button 3 = Sensitivity 3
Ž
button = Sensitivity 4
3 Press and hold the
4 seconds.
The change is saved.

Saturation display

If the metal grease filters are saturated, the
flashes.
If you have not yet done so, the metal grease filters
should be cleaned now.
For instructions on how to clean the metal grease filters,
please refer to the
Cleaning and maintenance
Resetting the saturation indicator
œ
Press the button.

Lighting

The lighting can be switched on and off independently
of the ventilation system.
Switching on or off
Press the ž button.
Setting the brightness
Press and hold the ž button until the desired
brightness is reached.

Safety shut-off

For your safety, the appliance has a safety shut-off
function. The lighting switches off after 12 hours and
the fan after 4 hours if the appliance is not operated
during this time.
Ž
button to change the
<
button for approx.
œ
section.
<
button