Metabo HPT CJ 90VST2 Manual De Instrucciones página 9

NOTE
○ Confi rm the protrusions of blade inserted to the blade
holder surely.
○ Confi rm the blade located between the groove of
guide roller. (Fig. 3)
Guide
Blade
roller
7. Switch operation (Fig. 4)
The switch will activate when pulled and will
deactivate when released.
For continuous operation, pull the switch in all the
way and press the stopper.
To cancel continuous operation, once again pull the
switch in all the way until the stopper is freed, and
then release the switch.
Stopper
8. Adjusting the blade operating speed
The jig saw is equipped with the electric control circuit
which enables stepless speed control. To adjust the
speed, turn the dial shown in Fig. 5. When the dial
is set to "1", the jig saw operates at the minimum
speed (850 /min). When the dial set to "6", the jig saw
operates at the maximum speed (3 000 /min). Adjust
the speed according to the material to be cut and
working effi ciency.
Dial
Guide
Blade
roller
Fig. 3
Switch trigger
Fig. 4
Fig. 5
CAUTION
● At low speed (dial setting: 1 or 2) do not cut a
wood with a thickness of more than 5/16" (8 mm)
or metal with a thickness of more than 1/32"
(1 mm).
9. Adjusting the orbital operation
(1) This Jig Saw employs orbital operation which moves
the blade back and forth, as well as up and down. Set
the change knob shown in Fig. 6 to "0" to eliminate
the orbital operation (the blade moves only up and
down). The orbital operation can be selected in 4
steps from "0" to "III".
(2) For the hard material, such as a steel plate, etc.,
decrease the orbital operation. For the soft material,
such as lumber, plastic, etc., increase the orbital
operation to increase work effi ciency. To cut the
material accurately, decrease the orbital operation.
10. Cutting stainless steel plates
This Jig Saw can cut stainless steel plates by using
No. 97 blade. Carefully read "Concerning cutting of
stainless steel plates" for proper operation.
11. Splinter guard (Sold separately)
CAUTION
Be sure to switch OFF and disconnect the plug
from the receptacle.
Using the splinter guard when cutting wood materials
will reduce splintering of cut surfaces.
Using the provided Hexagonal bar wrench, tighten
the bolts in the lower area of the base, moving the
base as far forward as possible. (Fig. 7)
Base bolt
Base
English
Change
knob
Fig. 6
Hexagonal bar wrench
Fig. 7
9