7.4 Normal operation
During normal operation, the drives connected can be moved up or down individually or parallel
(not synchronously). Press and hold the respective key on the hand switch for this purpose.
In event of a possible malfunction, pull out the mains plug immediately and inform the
specialist staff (service).
7.4.1 Operating the 2-key hand switch
•
When pressing the UP key of the hand switch, the drives connected move out until they reach
the limit switch.
•
When pressing the DOWN key of the hand switch, the drives connected move in until they
reach the limit switch.
The drive stops moving if the key is released or a limit switch
is activated.
When the key is released, the motor is short-circuited and
stops quickly.
When the end position is reached, drives with 8-pin connec-
tors are braked by shorting the motor, drives with 2-pin con-
nectors are not actively braked.
The design of the hand switch may vary.
7. Life phases
DOWN
UP
29