Dripping water may generate on the
surface of the indoor unit when cooling
in a high relatively humidity (relative
humidity higher than 80%). Adjust the
horizontal louver to the maximum air
outlet position and select HIGH fan
speed.
8. Heating mode (For cooling and
heating models only)
The air conditioner draws in heat
from the outdoor unit and releases
it via the indoor unit during heating
operation. When the outdoor
temperature falls, heat drawn in by the
ai conditioner decreases accordingly.
At the same time, heat loading of
the air conditioner increases due to
larger difference between indoor and
15. TROUBLESHOOTING
Trouble
OPERATION (RUN) indicator or other
indicators continue flashing.
If one of the following code appears
on the display area: E0,E1,E2, E3.....,
P0, P1, P2, P3...., or F0, F1, F2,
F3.......
Fuse blows frequently or circuit
breaker trips frequently.
Other objects or water fall into the air
conditioner.
Terrible odors are smelled or abnor-
mal sounds are heard.
outdoor temperature. If a comfortable
temperature can't be achieved by the
air conditioner, we suggest you use a
supplementary heating device.
9. Auto-restart function
• Power failure during operation will stop
the unit completely.
• For the unit without Auto-restart
feature, when the power restores, the
OPERATION indicator on the indoor
unit starts flashing. To restart the
operation, push the ON/OFF button on
the remote controller. For the unit with
Auto-restart feature, when the power
restores, the unit restarts automatically
with all the previous settings preserved
by the memory function.
The unit may stop operation
or continue to run in a safety
condition(depending on models).
Waiting for about 10 minutes, the
fault may be recovered automati-
cally, if not, disconnect the power
and then connect it in again. If the
problem still exists, disconnect the
power and contact the nearest
customer service center.
Stop the air conditioner immediately,
disconnect the power and contact
the nearest customer service center.
ENGLISH
37