Electrolux EXO27HEIWE Manual De Instrucciones página 24

24 www.electrolux.com
Dehumidifying Operation
C
A
Cooling/Heating/Fan Operation
D
A
SET TEMPERATURE( C)
AUTO FAN
COOL HIGH
DRY MED
HEAT LOW
TEMP
ON/OFF
MODE
FAN SPEED
HORIZONTAL/
TIMER ON
SLEEP
SWING
VERTICAL/
TIMER OFF
SWING
RESET LOCK
FOLLOW
TURBO
ME
SET TEMPERATURE( C)
AUTO FAN
COOL HIGH
MED
DRY
HEAT LOW
TEMP
ON/OFF
MODE
FAN SPEED
HORIZONTAL/
TIMER ON
SLEEP
SWING
VERTICAL/
TIMER OFF
SWING
RESET LOCK
FOLLOW
TURBO
ME
1. Press the MODE button to select DRY
mode.
2. Press the TEMP button to set the
desired temperature. The temperature
can be set within a range of
17ºC/62ºF~30ºC/88ºF in 1ºC/2ºF
increments.
B
3. Press the ON/OFF button to start the
air conditioner.
In the Dehumidifying mode, you
can not switch the fan speed. It
has already been automatically
controlled.
1. Press the MODE button (A) to select
COOL, HEAT (Reverse cycle models
only) or FAN mode.
2. Press the TEMP button (B) to
set the desired temperature. The
temperature can be set within a range
of 17ºC/62ºF~30ºC/88ºF in 1ºC/2ºF
B
increments.
3. Press the FAN SPEED button (C) to
C
select the fan speed in four steps -
Auto, Low, Med, or High.
4. Press the ON/OFF button (D) to start
the air conditioner. The OPERATION
indicator on the display panel of the
indoor unit illuminates. The operating
mode is selected in accordance with
the room temperature and operation
starts after approximately 3 minutes (If
you select FAN mode, the unit will start
immediately).
In the Fan mode, the setting
temperature is not displayed in
the remote controller and you
are not able to control the room
temperature either. In this case,
only step 1, 3 and 4 may be
performed.