Microsoft XBOX 360 Manual De Usuario página 18

ConnectyourHeadsettoyour
Controller
To connect your headset:
Turn down the volume by rotating the
1
volume control all the way to the left.
Insert the 2.5-mm headset connector into
the controller expansion port at the back of
your game controller.
Put on your headset and adjust the
2
microphone.
nOTE
Correct placement of the headset and
microphone is critical to using your headset
successfully. Make sure the headset goes
over the top of your head, not around the
back of your head. You may rotate the
microphone and earpiece to your right or
left side. Position the microphone about
one inch (2.54 cm) from your mouth and off
to one side. This will ensure that it doesn't
transmit your breathing into a chat session.
As you adjust the microphone, make sure
the microphone opening is pointed toward
your mouth and not rotated on its axis.
Now the headset is ready for a game or
3
chat session. Start your game or chat and
turn the volume up to a comfortable level.

useyourHeadset
To temporarily turn off voice transmission,
slide the mute switch on the headset control.
To adjust the listening volume of the headset,
rotate the volume control knob. For more
information about using your Xbox 360
Headset with a particular game, see your
game manual.
To chat and send voice messages, you need
an Xbox LIVE membership.
iMPOrTanT
To prevent damage to your headset, avoid
sitting or stepping on the headset, its cable, or
the cable connector.
Hearingloss
Extended exposure to high volumes when
using a headset may result in temporary
or permanent hearing loss. Some
unapproved third-party headsets may
produce higher sound levels than
approved Xbox 360 Headsets.