Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
2. TECHNICAL INFORMATION FOR APPLICATION AND OPERATION
The SLIM-LOCK electromechanical lock is a technical development for automatic locking of windows,
continuous facades and doors. It can be adapted to almost any type of profile in aluminium, PVC or wood
and performs the forward / backward movement of the sliding accessory of a window or door.
Mounted by itself the device is an effective protection against intrusion, blocking the latch of windows and
doors, but it's actually constructed to interface only with 24V═ (DC) chain actuators of the VARIA SLIM series
(VARIA SLIM PLUS, VARIA SLIM, VARIA SLIM SMALL), even in the S
and smoke and heat exhaust systems (RWA). The reduced cross-section (just 25x25 mm) allows recessed
insertion in the profiles.
The electromechanical lock is composed of a linear actuator that moves the locking hook of the sliding
accessory, with a selectable stroke of 18 or 36 mm. The easy-to-install mechanisms can be recessed or
mounted externally with just two screws.
3. TECHNICAL DATA
Model
Push and pull force
Strokes
Power supply voltage
Current absorbed at nominal load
Power absorbed at nominal load
No-load speed
No-load stroke time
Double electrical insulation
Insertion ratio
Service
Structure material
Operating temperature
Degree of protection for electrical devices
Opening and closing stroke-end
Operation with chain actuator
Operation without actuator
Power supply cable
Open/Close overload protection
Dimensions (mm)
Weight (kg)
The data provided in these illustrations is non-binding and subject to change, even without advance notice.
4. CONSTRUCTION AND REGULATORY REFERENCES
The SLIM-LOCK lock has been designed and constructed to move any sliding accessory, available on the
market, applied to doors or windows that have a pawl with Ø8.
- The electromechanical lock is constructed according to European Union directives and
certified in conformity with the
- Any service or control device must be manufactured according to current regulations
and in compliance with EC standards.
The electromechanical lock is composed of a small linear actuator that moves the locking hook with a 2 m
cable in silicone with three wires.
YNCRO
SLIM-LOCK 24V
600 N - 850 N starting force
18 mm / 36 mm
24V ═ (20,4÷30V═)
0,85 A during the stroke
1,2 A at intervention of the current interlock
4 s (18 mm) – 7,2 s (36 mm)
Extra-low voltage (SELV) device
Extruded aluminium alloy
-20°C - +70°C
Electronically preset
H05-VV-F 3x0,5mm² - PVC - 2,00m
Current cut-off due to power absorption
25.5 x 25.5 x 357
mark.
21
version, in natural ventilation
~ 20 W
5 mm/s
30 %
S
of 1 minute
2
IP 40
Selectable
Selectable
0.560
Publicidad
Tabla de contenido
