Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
12.3. LED Light signals
If there are any problems during installation or operation, consult the possible causes listed below:
Number of
Flashes
1
The electromechanical lock has
detected an overcurrent in the motor.
2
electromechanical lock and actuators
3
7
The internal encoder had a counting
Electric power supply error:
8
The power supply voltage is outside
the allowed range or unstable.
10
The internal memory write process
LED Status
STEADY-ON
LED Status
STEADY-ON
Duration < 0.5 sec.
Type of Error
Overload error:
Communication error:
Communication between the
is interrupted.
Error in the actuators
Encoder error:
error.
Memory error:
failed.
Device powered correctly.
The device executed a hook re-entry stroke correctly, completing the operation
by writing to the memory, or is in motion.
Internal memory write process in progress.
WITH RED LED
Check that there are no obstacles preventing it
from completing its stroke.
Check that it has been installed correctly.
Check the condition of the connection cables
and the setting of the actuator's dip-switches.
Check the error LED on the actuators.
Faulty electronic card.
Check the electrical contacts at the ends of the
lock's cable and ensure that the power supply
voltage is correct.
Faulty electronic card.
WITH GREEN LED
Meaning
WITH ORANGE LED
Meaning
31
Possible Solution
Publicidad
Tabla de contenido
