Start-Up Operations - GIESSE SLIM-LOCK Manual De Uso E Instalación

Connection of a SLIM-LOCK with several chain actuators in the Syncro version.
10.

START-UP OPERATIONS

- In order to prevent damage, do not apply the 24Vdc power supply voltage to the system
before having performed the start-up.
- Strictly following the work steps below will guarantee a problem-free installation.
10.1. With actuator
▪
The connections between chain actuator and SLIM-LOCK have been made and the operation
has already been bench tested; when opening, the SLIM-LOCK opens, goes to 18 or 36 mm (the
hook moves towards the outside of the machine) and then the chain of the actuator comes out.
When closing, first the chain of the actuator re-enters completely and then the SLIM-LOCK goes
to 0 (the hook moves towards the center of the machine towards the power supply cable).
Caution: before proceeding, remember to set the Dip-switch on the chain actuator (see the
respective instructions manual).
▪
Keep the window unhooked from the chain.
▪ If necessary, operate on dip-switch 1 to correct the stroke; (see Chapter 7. "Setting the dip-
switches").
▪ upply power [24V═ (DC)] and move the hook into the opening stroke-end position (18 or 36),
then cut off the power.
▪
Hook up the window, i.e. check that the hook is inserted in the pawl of the sliding accessory.
▪
Supply power again and check operation of the assembly, which must be the same as seen in
the bench test.
▪
Repeat the complete cycle a second time.
▪
Now if everything works perfectly, check that all the screws are tightened correctly and the cables
are orderly and well-protected.
10.2. Without actuator (test)
▪
Ensure that the hook is inserted in the pawl of the sliding accessory and can move.
▪
Select dip2=OFF and dip1 according to the desired stroke.
▪ upply the power supply voltage [24V═ (DC)]: check the
on the power supply orientation on wire 1. The movement must be complete up to the stroke-end
without obstacles.
2
+
2
29
24V
C
PE or CL E movement, depending