Replacing Parts; Instructions And Warning For Replacing Parts; Replacing The Plate Burner Nozzle; Replacing The Top Burner Nozzle (Ø 110 - 7 Kw) - Angelo Po 1N1TPGV Manual De Uso

INSTRUCTIONS AND WARNING FOR REPLACING PARTS

Important
Before carrying out any servicing procedure,
activate all the safety devices provided and
decide whether staff at work and those in the
vicinity should be informed.
In particular, turn off the gas supply tap, cut
off the electricity supply using the master
switch and prevent access to all devices that
might cause unexpected health and safety
hazards if turned on.
To carry out this operation, proceed as follows.
Turn off the gas supply tap.
1)
Pull off the knob (A).
2)
Undo the screws (C) and remove the control
3)
panel (B).
Unscrew the nozzle (D) and replace it with
4)
the one suitable for the type of gas in use (see
table at back of manual).
Replace the control panel (B) and the knob
5)
(A) on completion of the operation.
REPLACING THE TOP BURNER NOZZLE (Ø 110 - 7 KW)
To carry out this operation, proceed as follows.
Turn off the gas supply
1)
tap.
Remove the grid (A).
2)
Extract the burner (B).
3)
Unscrew the nozzle (C)
4)
and replace it with the
one suitable for the type
of gas in use (see table at
back of manual).
Replace the burner and
5)
the grid.
3320110_inst_GB_rev.1

REPLACING PARTS

REPLACING THE PLATE BURNER NOZZLE

A
Also make sure that during the maintenance
procedure, that the operator is always able
to check whether the plug is disconnected
from the power outlet.
If worn parts have to be replaced, use origi-
nal spare parts only. The manufacturer de-
clines all responsibly for injury or damage to
components due to the use of non original
parts, or extraordinary work on the applian-
ce which may modify the safety requirements
without the manufacturer's authorisation.
When ordering components, follow the in-
structions provided in the parts catalogue.
A
B
B
- 17 -
C
C
D
GB
8
C
ENGLISH