Testing Of The Appliance; Adjustments; Instructions And Warnings For Adjustments; Replacing Parts - Angelo Po 0N0VT1W Manual De Uso

Tabla de contenido

Idiomas disponibles

Important

Before it is put into service, the system must

be tested to check the operating conditions

of every single component and identify any

malfunctions. In this stage, it is important to

check that all health and safety requirements

have been complied with in full.

To test the system, make the following checks:

Make sure that the mains voltage is the same

as that of the appliance.

The appliance's main functions do not require

any special adjustments by specialist staff except

the settings made during use by the user.

INSTRUCTIONS AND WARNINGS FOR THE REPLACEMENT OF PARTS

The appliance does not require the replacement

of operating components by specialist staff

except the replacement of standard parts which

can be carried out by the user.

EQUIPMENT DECOMMISSIONING, DEMOLITION AND DISPOSAL

decommissioning and scrapping the appliance

When decommissioning the appliance, a series

of procedures must be carried out to ensure that

the appliance and its components are not a hin-

drance and are not easily accessible.

To ensure that the appliance cannot constitute

hazards for people or the environment, all energy

sources (electricity, etc.) must be disconnected

and rendered unusable, and any liquids present

must be drained (lubricants, fl uids, etc.).

Place the appliance in a suitable area which is not

easily accessible, with barriers to prevent anyone

from accessing it.

3301370_inst_GB_rev.1