Electrical Connection - Angelo Po 1N1TPGV Manual De Uso

Important
The equipment comes with a cable to con-
nect it to the outlet of the disconnecting
switch. If it is necessary to change the cable,
proceed as described below.
Important
The connection must be made by authorised,
skilled personnel, in accordance with the re-
levant legal requirements, using appropriate
and specifi ed materials. The appliance is sup-
plied at an operating voltage 230V1~N 50 Hz.
Caution - Warning
Before doing any work, cut off the mains
electricity supply.
Connect the appliance to the mains electricity
supply as follows:
If not already present, install a circuit-breaker
1)
(A) with overload cutout and diff erential safe-
ty breaker close to the appliance.
B
D
3320110_inst_GB_rev.1

ELECTRICAL CONNECTION

C
E
C
Pull off the knob (B).
2)
Undo the screws (C) and remove the control
3)
panel (D) to access the electric box (E).
Undo the screws (F) to remove the lid (G).
4)
Connect the circuit-breaker (A) to the termi-
5)
nal board (H) of the appliance as shown in the
diagram and in the electrical system diagram
at the back of the manual.
Use a fl exible cable with at least type H07RN-F
characteristics, rated for an operating tempe-
rature of at least 80°C.
Important
When connecting, take care to connect the
phase and neutral lines.
Replace all on completion of the operation.
6)
F
- 11 -
A
G
GB
H
ENGLISH