Replacing The Top Burner Pilot Light Nozzle; Replacing Oven Burner Pilot Light Nozzle; Equipment Decommissioning, Demolition And Disposal - Angelo Po 1N1TPGV Manual De Uso

REPLACING THE TOP BURNER PILOT LIGHT NOZZLE

To carry out this operation, proceed as follows.
Turn off the gas supply tap.
1)
Pull off the knob (A).
2)
Undo the screws (C) and remove the control
3)
panel (B).
Remove the pipe (D).
4)
Remove the nozzle (E) and replace it with the
5)
one suitable for the type of gas in use (see
table at back of manual).
Replace the pipe (D).
6)
Replace the control panel (B) and the knob
7)
(A) on completion of the operation.

REPLACING OVEN BURNER PILOT LIGHT NOZZLE

To carry out this operation, proceed as follows.
Turn off the gas supply tap
1)
Access the pilot light through the opening
2)
provided in the bottom of the appliance.
Unscrew the cap (B).
3)
Remove the nozzle (C) and replace it with the
4)
one suitable for the type of gas in use (see
table at back of manual).
Replace the cap (B).
5)

EQUIPMENT DECOMMISSIONING, DEMOLITION AND DISPOSAL

When decommissioning the appliance, a series
of procedures must be carried out to ensure
that the appliance and its components are not a
hindrance and are not easily accessible.
To ensure that the appliance cannot constitu-
te hazards for people or the environment, all
energy sources (electricity, etc.) must be discon-
nected and rendered unusable, and any liquids
present must be drained (lubricants, fl uids, etc.).
Place the appliance in a suitable area which is
not easily accessible, with barriers to prevent
anyone from accessing it.
3320110_inst_GB_rev.1
A
B
When scrapping, sort all components by
chemical characteristics and dispose of them
separately in accordance with the relevant legal
requirements.
Important
Do not dump non-biodegradable products,
lubricating oils, and non-metallic compo-
nents (rubber, PVC, resins, etc.) in the envi-
ronment. Dispose of them in compliance with
the relevant laws.
- 19 -
D E
C
C
C
B
10
GB
ENGLISH