Meaning Of The Led Flashing Mode; Checking For Correct Assembly - GIESSE VARIA SLIM RADIO Manual De Uso

the pin into the hole on the bracket. Attach the
safety clip to the bracket.
J. Check that the exit of the chain is perfectly aligned
with the bracket. If the chain is not aligned, loosen
the fixing screws and reposition the bracket
correctly.
K. Check all electrical connections with the diagram on
the label attached to the lead and in conformity to
indications on chapter 9 – Electrical connection.
L. Carry out a complete check of opening and closure
of the window. Once the closure phase has been
completed, check that the window frame is
completely closed by checking the pressure on the
weather strips.

15. Meaning of the LED flashing mode

The LED can be seen on the electronic board after removing the closure plug. In
some cases it flashes in different ways depending on the signal it is emitting; the
different flashing modes indicate the precise behavior of the actuator during the
programming of the machine, radio remote control or rain sensor.
The table below summarizes the meaning of the LED flashing mode.
Ref. Flashing
1 Off
2 Steady-on
Slow flashing
3
for 10 seconds
On for
4
2 seconds
Flashing for
5
2 seconds
Fast continuous
6
flashing
Flashing for 5
7
seconds

16. Checking for correct assembly

• Check that the window has closed completely, even at the corners, and check
there are no obstacles caused by assembly in the wrong position.
• Check that when the window frame is closed, the chain terminal is at least a
couple of millimetres distant from the actuator body. This will ensure correct
Flashing
frequency
1 per second
Steady-on
2 per second
2 per second
2 per second
44
Meaning
Actuator at rest, no alarm is active
Function not provided for
The machine is waiting to receive a
valid radio remote control code.
The machine has saved the radio
remote control correctly
The machine has not saved the radio
remote control
Rain sensor active
Erasing the radio remote control
memory
Figure 14
Figure 15