Craftsman CMXGWAS020733 Manual Del Operario página 11

Usage Tips
• For most effective cleaning, keep spray tip 8 to 24 in
(20 to 61 cm) away from cleaning surface .
• Do not use high pressure spray tips closer than 6 in (15
cm) to prevent damage to the cleaning surface .
• Start at the top of the area to be rinsed, working down
with long, even, overlapping strokes .
Step 6: Applying Detergent
WARNING! Chemicals could cause burns resulting
in death or serious injury .
• Follow chemical manufacturer's label instructions for
proper use and handling of the chemical .
• Only use products marketed for use with pressure
washers .
• Never spray flammable liquids .
Check Detergent Siphoning Tube / Tank
Clean detergent tube if clogged or replace if leaking .
To apply detergent, follow these steps:
1 . Prepare pressure washer detergent per manufacturer's
instructions .
2 . Remove cap from detergent tank and fill with
detergent solution . Replace cap .
3 . Install black detergent spray tip . See Spray Tips .
4 . Apply per manufacturer's instructions .
NOTICE Detergent cannot be applied with the high
pressure spray tips (White, Yellow or Red) .
Step 7: Shut Down
1 . Release spray gun trigger and let engine idle for one
minute .
2 . Push engine switch to OFF (0) position .
WARNING! Spray gun traps high water pressure,
even after engine shut down and water
disconnection, which could result in serious
injury .
3 . Point spray gun in safe direction . Press trigger lock
and depress trigger to relieve high water pressure .
Step 8: Clean Up
1 . Turn off water and purge system .
2 . Disconnect and drain all hoses, spray gun and spray
wand .
3 . Empty pump of all liquids by pulling recoil handle
about six times .
NOTICE If storing in freezing temperatures or more than
30 days, see Storage.
Operation
11