Energy Saving Mode; Setting The Clock - V2 PROTEO12-D Manual De Instrucciones

ENERGY SAVING mode

ENERGY SAVING mode is activated when the keys are not
operated for at least 1 minute.
When the ENERGY SAVING mode is active, the display turns off to
save power and turns on in the following conditions:
• When you press any key
• When an event occurs (AUTO mode).
The display shows (example)
This display indicates that the current event corresponds to an
opening command for channels 1 3 5 12 at 8.30 am on
Sunday (Su)

Setting the clock

PROTEO12-D comes with batteries already inserted, simply press a
key on the remote to turn on the display.
If time and date settings are incorrect, proceed as follows to set:
1. The remote must be in AUTO mode.
If it is in MANUAL mode, press SELC for 10 seconds,
the display shows (example):
2. Press the MENU key until the PROG icon turns on while
EVENT blinks
3. Press the UP key, the TIME icon blinks
4. Press the MENU key, the icon of the day (eg Su) blinks:
5. Set the correct day using the UP and DOWN keys and press
the MENU key to confirm.
The hour digits blink:
6. Set the time using the UP and DOWN keys and press the
MENU key to confirm.
The minute digits blink:
7. Set the minutes using the UP and DOWN keys and press the
MENU key to confirm.
The TIME display blinks for 10 seconds.
If you want to change the time again press MENU and repeat
from step 4 onwards.
If the settings are correct, wait for 10 seconds, the icons TIME
and PROG turn off, the new parameters are stored and the
display returns to normal viewing:
16