V2 PROTEO12-D Manual De Instrucciones página 20

AUTOMATIC operation logic
The AUTOMATIC operation logic of the remote PROTEO12-D
allows automatic control of the automations based on the
scheduled EVENTS.
NOTE: Before proceeding with event programming, make
sure that the time and date settings are correct.
To control the different automations it is necessary to save
PROTEO12-D in the different devices.
NOTE: store the channels with a suitable logic so as to
simplify the management of the automations.
To store PROTEO12-D in the control units, the MANUAL mode
must be active; follow the procedure described in the
instruction manual provided with the control units.
Events scheduling
1. The remote must be in AUTO mode.
If it is in MANUAL mode, press SELC for 10 seconds,
the display shows (example)
2. Press the MENU key until the PROG icon turns on while
EVENT blinks
3. Press the MENU key to confirm:
EVENT is steadily on and the icon of the day (e.g. Su) blinks.
4. Select the day on which you want to set up the event by using
the UP / DOWN keys and press MENU to confirm.
The display will show event number 1
5. Select the event (1 to 5) using the UP / DOWN keys and press
the MENU key to confirm.
The hour digits blink:
6. Set the time using the UP and DOWN keys and press the
MENU key to confirm. The minute digits blink:
7. Set the minutes using the UP and DOWN keys and press the
MENU key to confirm.
The icon of Channel 1 blinks showing its state ON (active)
or OFF (inactive)
8. Set the channels which must transmit for this event:
using the UP and DOWN keys, select the ON (active) or
OFF (off) state of the channel, press MENU to confirm and
proceed to set the next channel.
9. Repeat this procedure for all 12 channels.
NOTE: This step allows you to associate multiple
channels to the same event by creating groups of
channels that will be activated simultaneously.
When channels are activated they stay on.
18