Standard Equipment - Comet MC 8-18 Manual De Instrucciones

Tabla de contenido

Idiomas disponibles

WARNING

• This part of the manual is intended for the

WARNING

• Wear gloves and safety goggles when unpacking to protect your hands and eyes.

• Packaging materials (plastic bags, clamps etc.) can be dangerous: never leave them within the reach of

children.

• Dispose of packaging materials properly according to the current regulations where the pump is installed.

Plastic bags and other plastic materials are not eco-friendly.

• After unpacking the pump, check it is not damaged and make sure its identification plate is attached to the

case.

In case of doubt, do not use the pump and contact your dealer.

Make sure that pump supplied also has the following:

• operating and maintenance manual;

• guarantee certificate.

Contact your dealer in case of doubt.

WARNING

• These instructions and the guarantee certificate must always accompany the pump and be handed over to

the end user of the pump.

WARNING

• It is the responsibility of the

The specifications of the motor (electric motor or combustion engine) to be connected to the pump must

be suitable for the performance and the specifications of the pump (power, speed of rotation, flanges, etc.)

listed in the technical documents provided by the Manufacturer.

• The design of the machine with the pump must safeguard compliance with the safety standards required by

European Directives. This conformity is guaranteed by the

issued by the Manufacturer of the machine with the pump.

• The pump must be installed and operated horizontally.

• The pump must be secured in a stable manner.

• As this is a positive-displacement pump, it must always be fitted with a pressure control/limit valve.

CAUTION

• Pump applications must comply with the principals of good mechanics. The Manufacturer's Service

Department can provide any additional information for installers.

CONNECTION TO AN ELECTRIC MOTOR (8 AND 18 ONLY)

These pumps can be connected directly (no reduction unit necessary) to a MEC 71, 4-pole (50/60 Hz)

electric motor (Ø 14 mm drive shaft) with a B14 type flange or a NEMA 56, 4-pole (50/60 Hz) electric

PART TWO

(FOR THE SKILLED TECHNICIAN ONLY)

SKILLED TECHNICIAN

UNPACKING