Replacement Blades - Ryobi RY48ZTR75 Manual Del Operador

REPLACEMENT BLADES

FOR USE WITH RYOBI ELECTRIC ZERO TURN LAWN MOWER
WARNING:
To reduce the risk of injury, user must read and under-
stand the operator's manual for their riding lawn mower
before using this accessory. Save these instructions.
Refer to them frequently and use them to instruct other
users. If you loan someone this product, loan them these
instructions also.
Combo blades and bagging blades are sold separately. For
purposes of the illustrations in this manual, only combo
blades are shown. However, bagging blades would install
in the same way.
INSTALLING BLADES
See Figures 1 - 2.
WARNING:
Only use replacement blades and blade bolts authorized
by the manufacturer of your riding mower. Unauthorized
blades and/or blade bolts could break, allowing the blade
to come loose, resulting in possible serious personal
injury and damage to the mower.
NOTE: Make certain all parts are replaced in the exact order
in which they were removed.
 Make sure drive levers are in open position and blade
engage knob is down.
 Stop the motor, remove the start key, and set the parking
brake.
 Raise the height of the cutting deck to its highest position
to allow access to blades.
NOTE: If necessary, raise the mower by placing on a lift
or using a jack and jack stands to gain access to the
blades.
WARNING:
If raising the mower to access the blades, make sure the
mower is properly secured and the parking brake is set
before proceeding. Failure to properly secure the mower
could cause it to fall, resulting in death or possible serious
personal injury.
 Wedge a block of wood between the blade and mower
deck to prevent the blade from turning.
 Loosen the blade nut by turning it counterclockwise (as
viewed from bottom of mower) using a 15 mm wrench
or socket (not provided).
ACRM006 COMBO BLADES
WRENCH
BLADE
CIRCLE HOLE
English
ACRM007 BAGGER BLADES
BLOCK OF WOOD
BLADE
CIRCLE
POST
SHAFT
CENTER
BLADE
HOLE
BLADE
NUT
SPRING
WASHER
BLADE
Fig. 1
BLADE HALF
CIRCLE POST
BLADE
HALF
CIRCLE
HOLE
BLADE
Fig. 2