Ryobi RY48ZTR75 Manual Del Operador página 3

 Remove the blade nut, spring washer, and blade.
 Place the new blade on the shaft against the corresponding
blade posts. Ensure blade is properly seated with shaft
going through center blade hole and the two blade posts
inserted into their respective holes on the blade. Make
sure it is installed with the curved ends pointing up toward
the mower deck and not down toward the ground. When
seated properly, the straight sides should be aligned and
the blade should be flat against the blade posts.
 Replace the spring washer, then thread the blade nut on
the shaft and finger tighten.
TECHTRONIC INDUSTRIES POWER EQUIPMENT
 Torque the blade nut down clockwise using a torque
wrench (not provided) to ensure the bolt is properly
tightened. The recommended torque for the blade nut is
600-650 in. lbs.
WARNING:
Ensure blade is properly seated and the blade nut is
tightened to the torque specifications above. Failure to
properly attach the blade could cause it to come loose
and result in possible serious personal injury.
 Repeat with second blade, if needed.
P.O. Box 1288
Anderson, SC 29622
1-800-860-4050
www.ryobitools.com
English
995000770
12-20-18 (REV:02)