Super User Key (Yellow) - Advance ecoflex SC2000 Instrucciones De Uso

ENGLISH

SUPER USER KEY (yellow)

The Super User (yellow) key allows you to check some additional information on some machine operating parameters and to adjust
others to your specific requirements.
Main Screen (E, Fig. 7)
1. Insert the Super User (yellow) key in place of the operator
(grey) key to access the main screen of the multifunction
display (51).
2. Press push-button (A) to change the machine settings (see
Machine Settings Screen section).
3. Press push-button (B) to check for any stored machine
alarms (see Alarms Log Screen section).
4. Press push-button (C) to check the machine's hours of
operation (see Operating Time Counter Screen section).
5. Press push-button (D) to exit service mode and return to
operator mode.
Machine Settings Screen (F, Fig. 7)
This function allows you to customise some parameters
described in the following table of modifiable parameters.
1. Press push-button (B) to increase the value of the current
parameter.
Press push-button (C) to decrease the value of the current
parameter.
2. Press push-button (A) to move to the next parameter.
3. To return to the main screen, press and hold the push-
button (A) for more than 1 second.
TABLE OF MODIFIABLE PARAMETERS
Code Description
CHM1 Detergent concentration level 1
CHM2 Detergent concentration level 2
P1/P3 Level 1 solution flow rate in relation to level 3
(flow rate as function of speed)
P2/P3
Level 2 solution flow rate in relation to level 3
(flow rate as function of speed)
P3 Level 3 solution flow rate (flow rate as function of speed)
P4 Enablement of level 4 (2.8 l/min regardless of speed)
SPT EcoFlex™ function timer
XPRES Brush deck extra pressure enablement
FVMAX
Maximum forward speed
RVMAX Maximum reverse speed
WSMIN Minimum working speed
WSMAX Maximum working speed
BRK Electromagnetic brake activation delay
BAT (**) Installed battery type (see table)
TOFF Automatic shut-off time
BRGH Display contrast
VRID Silent mode setting
RPM (*) Reduced brush rpm activation threshold
RESET Restore factory settings for all parameters
(*) Increase the value of this parameter to reduce the brush motor speed in a wider range of applications and vice versa.
20
INSTRUCTIONS FOR USE
SC2000 - 9100000386
E
F
Figure 7
Values
Minimum Factory Setting
0.25 % (1:500) 0.25 % (1:500)
0.25 % (1:500) 0.80 % (1:125)
0 % 25 %
0 % 50 %
1.0 cl/m 3.0 cl/m
OFF OFF
0 (disabled) 60 sec.
OFF ON
10 % 100 %
10 % 40 %
10 % 25 %
10 % 100 %
0 sec. 3 sec.
0 1
0 (disabled) 300 sec.
5 20
1 1
5 9
OFF OFF
A
B
C
D
P100869
Maximum
3 % (1:33)
3 % (1:33)
100 %
100 %
5.0 cl/m
ON
300 sec.
ON
100 %
50 %
100 %
100 %
5 sec.
5
600 sec.
50
5
20
ON
01/2015