Cleaning And Maintenance - HQ-Power VDPLT2 Manual Del Usuario

4. Description
1. LED tube
2. mounting clips (w/ screws)
3. male input connector
4. female output connector
5. Connection
1. Signal input: Low voltage signal input to be connected with the signal output from the previous tube or with
the controller.
2. Signal output: Low voltage signal output to be connected with the signal of the next tube. If there is no
further tube to be connected, you must seal this connector against humidity if the tubes are used outdoor.
• The tube(s) should be installed out of reach of people and outside areas where people can walk or touch the
tube(s).
• Install the included clips in a proper and safe way. Make sure the surface is strong enough and is able to
carry the structure.
• Click the tubes into the clips.
• Interconnect the tubes and the VDPLTC2 controller (not incl.) through the input/output connectors. Make
sure the connectors are properly connected.

6. Cleaning and Maintenance

1. All screws should be tightened and free of corrosion.
2. The housing, the mounting supports and the installation location (e.g. ceiling, suspension, trussing) should not be
deformed, modified or tampered with e.g. do not drill extra holes in mounting supports, do not change the location
of the connections...
3. Mechanically moving parts must not show any signs of wear and tear.
4. The electric power supply cables must not show any damage. Have a qualified technician maintain the device.
5. Disconnect the device from the mains prior to maintenance activities.
6. Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
7. There are no user-serviceable parts.
8. Contact your dealer for spare parts if necessary.
VDPLT2/VDPLT3/VDPLT4
3
VELLEMAN