Operating A Cable Box Or Dbs Receiver - Sony KP-48V45 Manual De Instrucciones

Operating a cable
box or DBS receiver
You can program the supplied remote control to
operate a cable box or DBS receiver. Follow the
procedures below to set the manufacturer's code
number in the remote control.
DISPLAY*
1
4
7
JUMP
TV/DBS*
CODE SET
* The TV/DBS, GUIDE, DISPLAY, V/v/B/b/
buttons can be used only with a DBS receiver.
1
Turn off the equipment you want to set up,
and press DBS/CABLE (FUNCTION).
FUNCTION
DBS/CABLE
2
Press the CODE SET, DBS/CABLE (FUNCTION),
and 0 – 9 buttons to enter the
manufacturer's code number (see the chart
on the right column), then press ENTER. For
example, to program your remote control
to operate a Sony DBS receiver, press CODE
SET, DBS/CABLE (FUNCTION), 8, 0, 1, and
ENTER.
FUNCTION
CODE SET DBS/CABLE
8
DBS/CABLE (POWER)
DBS/CABLE
(FUNCTION)
2 3
0 – 9 buttons
5 6
8 9
0 ENTER
GUIDE*
*
V/v/B/b/
MENU*
CH +/–
, and MENU
ENTER
1
0
3
Press DBS/CABLE (POWER) to turn on the
cable box or DBS receiver.
DBS/CABLE
4
Use the cable box/DBS control buttons to
check if the code number works.
For example, to operate a cable box or DBS receiver,
you can use the DBS/CABLE (POWER), JUMP, CH
+/–, 0 – 9 and ENTER buttons.
Note
• If the cable box or DBS receiver does not have a certain
function, the corresponding button on this remote control will
not operate.
To operate the projection TV
Press TV (FUNCTION). Then use the projection TV
control buttons to control the projection TV.
For more details on operating the cable box or
DBS receiver
Refer to the operating instructions that come with the
equipment.
If the remote control doesn't work
• First, try repeating the setup procedures using the other codes
listed for your equipment.
Manufacturer code numbers (cable box)
Manufacturer
Hamlin/Regal
Jerrold/G. I.
Oak
Panasonic
Pioneer
Scientific Atlanta
Tocom
Zenith
Manufacturer code numbers (DBS receiver)
Manufacturer
Sony
RCA
Notes
• If more than one code number is listed, try entering them one
by one until you come to the correct code for your equipment.
• If you enter a new code number, the code number you
previously entered at that setting is erased.
• In some rare cases, your equipment may use a code that is not
provided with this remote control and you may not be able to
operate your equipment with the supplied remote control. In
this case, use the equipment's own remote control unit.
• Whenever you remove the batteries — to replace them, for
example — if too much time is taken, the code numbers may
revert to the factory setting and must be reset.
Code number
222, 223, 224, 225, 226
201, 202, 203, 204, 205, 206, 207, 208,
218
227, 228, 229
219, 220, 221
214, 215
209, 210, 211
216, 217
212, 213
Code number
801 (preset code for the supplied
remote control)
802
41
Operations
EN
-EN