Operating A Cable Box Or Dbs Receiver - Sony KP-53XBR4CT Manual De Instrucciones

Operating a cable
box or DBS receiver
You can program the supplied remote commander to
operate a cable box or DBS receiver. Follow the
procedures below to set the manufacturer's code
number to operate it.
CABLE POWER
CABLE FUNCTION
CODE SET
1
4
7
(with the lid open)
1
Turn off the equipment you want to set up
and press FUNCTION of the equipment you
want to set up (CABLE or DBS).
FUNCTION
CABLE
2
Press CODE SET, then press 0 – 9 to enter
the manufacturer's code number (see the
chart below) and press ENTER. For
example, to program your remote
commander to operate a Zenith cable box,
press CODE SET, 2, 1, 2 and ENTER.
CODE SET
+ +
2
DBS POWER
DBS FUNCTION
TV FUNCTION
2 3
5 6
0–9 buttons
8 9
ENTER
0
CH +/–
DBS
ENTER
+ +
1 2
3
Press CABLE POWER to turn on a cable box
or DBS POWER when you use a DBS
receiver.
CABLE
4
Use the pojection TV control buttons to
check if your code number works.
For example, to operate a cable box, you can use the
CABLE POWER, JUMP, CH +/–, 0–9 and ENTER
buttons.
To operate a DBS receiver, you can use the DBS
POWER, JUMP, DISPLAY, MENU and 0–9 buttons,
and the joystick.
To operate the projection TV
Press TV FUNCTION. Then use the projection TV
control buttons to control the projection TV.
For more details on operating the cable box or
DBS receiver
Refer to the operating instructions that come with the
equipment.
If the remote commander doesn't work
• First, try repeating the setup procedures using the other codes
listed for your equipment.
• If — after trying all the codes listed for your equipment — you still
cannot get the remote commander to work properly, try the
learning function described on page 42.
Manufacturer code numbers (cable box)
Manufacturer
Hamlin/Regal
Jerrold/G. I.
Oak
Panasonic
Pioneer
Scientific Atlanta
Tocom
Zenith
Manufacturer code numbers (DBS receiver)
Manufacturer
Sony
RCA
Notes
• If more than one code number is listed, try entering them one by
one until you come to the correct code for your equipment.
• If you enter a new code number, the code number you previously
entered at that setting is erased.
• In some rare cases, your equipment may use a code that is not
provided with this remote commander and you may not be able to
operate your equipment with the supplied remote commander. In
this case, use the equipment's own remote control unit or use the
learning function (page 42).
• Whenever you remove the batteries — to replace them, for
example — if too much time is taken, the code numbers revert to
the factory settings and must be reset.
POWER
DBS
Code number
222, 223, 224, 225, 226
201, 202, 203, 204, 205, 206, 207, 208,
218
227, 228, 229
219, 220, 221
214, 215
209, 210, 211
216, 217
212, 213
Code number
801
802
41
Operations
EN
-EN