Operating Elements; Setting Up The Cleaner; Set The Brake - Nilfisk Alto NEPTUNE 4 FA Instrucciones De Manejo

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 345
2.2

Operating elements

See fold-out page at front of these
operating instructions.
3 Before starting the cleaner
3.1

Setting up the cleaner

3.2

Set the brake

1)
Options / model variants
1 Spray lance
2 Spray lance storage
3 Control panel
4 Pressure gauge
5 Tank fi ller for fuel
6 Receptacle for service
crane and lifting ring
7 Top cover release
8 Crank handle for
High pressure hose
reel
(Neptune..X)
9 High pressure hose
connection for machines
without hose reel
10 Main switch with
temperature controller
Every fuel-burning appliance,
such as pressure washers, de-
pends upon a proper mix of fuel
and air (by
weight) for proper
combustion. Therefore some
adjustment of the air regulation
to the burner may be necessary
to take account of altitude and
the resulting air pressure. This
is true whether your fuel is 'Nat-
ural gas', Propane or Diesel.
Your Nilfisk-ALTO hot water
pressure washer was thor-
oughly tested and adjusted for
11 Detergent metering knob
12 Power ON
13 Pump oil low
14 Service interval due/expired
15 Nilfi sk-ALTO AntiStone low
16 Fuel low
1)
1)
17 Castor with parking brake
18 Supply water connection
19 Tank fi ller for anti-freeze
20 Tank fi ller for Nilfi sk-ALTO
AntiStone
21 Canister for detergent
22 High pressure hose
reel
(Neptune..X)
23 Cable hook
24 Grip for top cover
optimum performance before
it left our factory. The factory is
located at approximately 120m
(390 ft) above sea level, and the
combustion settings are optimal
for that elevation.
If your location is higher than
1200m (3900 ft) above sea
level, your burner may require
re-adjustment for proper per-
formance and best fuel econ-
omy. Contact your Dealer or
Nilfisk-ALTO for assistance.
1.
Before using the cleaner for
the first time, check it care-
fully to detect any faults or
damage.
2.
Run the machine only when
it is in perfect condition.
3.
Set the brake.
4.
The slope of which the high
pressure cleaner is placed
must not exceed more than
10° in any direction.
NEPTUNE 4 FA
1)
1)
1)
5

Publicidad

Tabla de contenido
loading

Tabla de contenido