AL-KO 351-1201 Plus Manual De Instrucciones página 16

en
Fault
Load pressure brake
does not open
Load pressure brake
does not close
Lowering difficult with or
without load
ADVICE
In the case of faults that are not listed in this table, or faults that you cannot rectify without
assistance, please contact our customer service department.
16
Cause
Brake disc mechanism or brake
discs tight
Crank handle not fully wound in du-
ring assembly and tightened with
skt.- screw
Crank handle thread is stiff
Solution
Winch must be without a load! Re-
lease the brake by hitting the crank
handle gently with a hand in the di-
rection "Lower"
If necessary, block the gears un-
til the crank handle is loosened
Grease the crank handle thread
See crank handle assembly and
testing information
Grease the crank handle thread.
351 - 1201 Plus
Troubleshooting