FALMEC PRISMA Manual De Instrucciones página 19

With the Timer function activated, the hood can be switched-off by the operator in any
case and the function will be deactivated.
The Timer function remains associated to a velocity. A change in the velocity, with the
Timer function activated, will deactivate it.
2: 1st Velocity
When the LED is switched-off, non-prolonged pressing of the key will switch-on the hood
at the 1 st velocity and illuminate the respective LED. The function will switch-on when the
Key is released.
When the LED is switched-off and another velocity is activated, pressing the Key will
imply selection of the 1 st velocity, switching-on of the respective LED and switching-off of
the LED associated with the velocity that was previously selected.
When the LED is on, pressing the Key will imply the switching-off the LED and MOTOR.
When the LED is switched-off, prolonged pressing (at least 3 seconds) of the Key will
cause activation of the recirculation function. During the recirculation function (with a
duration of 24 hours), the LED will flash. From the activation of this function, the hood will
remain switched-on for one hour at the 1 st velocity, after which it will switch-off for 3 hours
and then reactivate for another hour. These cycles are repeated until the timeout.
With this function activated, the other functions cannot be selected. To remove this func-
tion, keep Key 2 pressed for at least 3 seconds.
3: 2nd Velocity
When the LED is switched-off and another velocity activated, pressing the Key (either
prolonged or not) will imply the selection of the 2 nd velocity, switching-on of the respec-
tive LED and switching-off of the LED associated with the velocity that was previously
selected.
When the LED is switched-off and no velocity activated, pressing the Key will have no
effect.
When the LED is switched-on, pressing the Key 3 will have no effect.
To switch the hood off, it will be necessary to firstly select the 1 st velocity and then repress
the same Key.
4: 3rd Velocity
When the LED is switched-off and another velocity activated, pressing the Key (either
prolonged or not) implies the selection of the 3 rd velocity, the switching-on of the re-
spective LED and switching-off of the LED associated to the velocity that was previously
selected.
When the LED is switched-off and no velocity activated, pressing the Key will have no
effect.
When the LED is switched-on, pressing the Key 4 will have no effect.
To switch the hood off, it will be necessary to firstly select the 1 st velocity and then repress
the same Key.
5: 4th Velocity
When the LED is switched-off and another velocity activated, pressing the Key (either
prolonged or not) implies the selection of the 4 th velocity, switching-on of the respective
LED and switching-off of the LED associated to the velocity that was previously selected.
When the LED is switched-off and no velocity activated, pressing the Key will have no
effect.
When the LED is switched-on, pressing the key 5 will have no effect.
The forth velocity must remain on for a maximum of 7 minutes, after which, one must
return to the third.
To switch the hood off, it will be necessary to firstly select the 1 st velocity and then repress
the same key.
6: Light
Briefly pressing key T6 will turn the light on and off. The T6 key will light up if the light is on.
17