Care And Maintenance - Linea 2000 DOMO DO926BFK Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 53
www.domo-elektro.be
very quickly on the evaporator, and your refrigerator.
Before connecting your refrigerator to the power supply, check that the voltage
stated on the rating label of your appliance corresponds to the voltage in your
home. A different voltage could damage the appliance.
The appliance must be grounded. The manufacturer is not responsible for
damages that may occur as a result of usage without grounding.
For uneven surfaces, front feet can be aligned.
After installation, leave the freezer for 3 hours before turning it on. This way the
refrigerant can settle.

CARE AND MAINTENANCE

Cleaning
Do not use abrasive cleaning agents or solvents.
1. Set the temperature control knob to the OFF position and disconnect the mains
plug from the mains socket.
2. Take out the food and store in a cool location.
3. Clean the appliance with a soft cloth, warm water and detergent.
4. Wipe the door seal with clear water only and then wipe dry thoroughly.
5. After cleaning reconnect and adjust the temperature control knob as desired.
6. Put the food back into the appliance.
Bulb replacement
Beware: Unplug the appliance from the power supply before replacing the light bulb.
1. Remove the bulb cover by pushing it upwards.
2. Unscrew the old bulb and then screw a new 15W (E14 base) bulb.
3. Replace the bulb cover.
DEFROSTING
The refrigerator defrosts fully automatically.
While the cooling is running, beads of condensation or hoarfrost form at the back
of the refrigerator. This is normal. It is not necessary to wipe off the condensation
or frost. The rear panel defrosts automatically. The condensation runs into the
condensation channel and is conveyed to the cooling from where it evaporates.
Note: Keep the condensation channel and drainage hole clean, so that the condensation
can run out.
A layer of frost in the freezer will impair refrigeration of the frozen food and increases
power consumption. Remove the layer of frost regularly. Do not scrape off frost or ice
with a knife or pointed object. Doing this may damage the refrigerant tubes.
1. Remove the frozen food and place temporarily in a cool location.
2. Disconnect the appliance from the mains socket.
3. To accelerate the defrosting process, place a pan of hot water on a stand in the
freezer.
45
DO926BFK

Publicidad

Tabla de contenido
loading

Tabla de contenido