Linea 2000 DOMO DO926BFK Manual De Instrucciones página 50

fridge compartment door�
DO926BFK
t
2� Remove three screws with suitable tools� Remove the upper hinge then take off carefully the
fridge compartment door�
1. Remove the cover plate of the screws. Remove the three screws and then the
upper hinge that holds the door in place. Lift the door off and place it on a soft
2� Remove three screws with suitable tools� Remove the upper hinge then take off carefully the
surface to prevent scratching.
r
3� Remove middle hinge, screws, screw caps and plastic inserting nails� Install them on the other
GB
side� Take off the lower door and put it away�
ct
3� Remove middle hinge, screws, screw caps and plastic inserting nails� Install them on the other
3� Remove middle hinge, screws, screw caps and plastic inserting nails� Install them on the other
GB
GB
2. Remove the centre cover plates, screws and hinge. Place them on the other side. side� Take off the lower door and put it away�
Lift the door off and place it on a soft surface to prevent scratching.
4� The disassembly and installation of bottom parts :
A� Disassemble lower hinge and screws� Then install them on the other side and consolidate the
lower hinge�
4� The disassembly and installation of bottom parts :
3. Remove the lower screws, hinge and the adjustable foot from the base of the
Note: the refrigerator-freezer incline angle less 45°�
4� The disassembly and installation of bottom parts :
appliance.
A� Disassemble lower hinge and screws� Then install them on the other side and consolidate the
lower hinge�
Note: the refrigerator-freezer incline angle less 45°�
B� Swap over the position of the adjustable foot to the other side of the cabinet�
4. Remove the adjustable foot from the other side of the base and move it to the
same position on the opposite side of the base.
B� Swap over the position of the adjustable foot to the other side of the cabinet�
10
5. Fasten the screws, hinge bracket and the adjustable foot to the other side of the
base.
10
6. Carefully replace the bottom part of the door into position. Make sure that the
door is aligned horizontally as well as vertically so that the seal is closed on
all sides before you tighten the centre hinge completely. Return the hinge to its
positions and fasten it.
10
Reverse door
Follow the following stages to reverse the door from its initial position�
1� Remove the hinge cover�
fridge compartment door�
side� Take off the lower door and put it away�
A� Disassemble lower hinge and screws� Then install them on the other side and consolidate the
lower hinge�
Note: the refrigerator-freezer incline angle less 45°�
B� Swap over the position of the adjustable foot to the other side of the cabinet�
Remove three screws
Remove three screws
Remove three screws
50
Remove the hinge cover
5�
6�
7�
8�
9�