Tig Welding. Installation And Start-Up; Mma Welding. Installation And Start-Up - GALAGAR GALA 2000 MP Manual Técnico De Instrucciones

3.3. TIG WELDING. INSTALLATION AND START-UP AND
3.3.1 TIG SYSTEM INSTALLATION. TORCH TO NEGATIVE POLE.
MARK
1
5
9
6
10 19051704P
12
3.3.2 TIG SYSTEM START-UP.
1) Make sure the mains voltage is 230 V.
2) Connect supply cable with the suitable plug to the relevant single-phase tap. See section 2.2.
3) Verify that the torch polarity is negative.
4) Check that the gas is Argon. If it has a mobile workstation, check that the gas bottle is securely held by the bottle-holder
system. Above all check that the safety chain is perfectly fastened.
5) Install the pressure-reducing valve and connect gas hose checking that there are no leakages, throughout the whole circuit.
3.4. COATED ELECTRODE WELDING (MMA). INSTALLATION AND START-UP
3.4.1 MMA INSTALLATION SYSTEM. ELECTRODE-HOLDER CLAMP TO POSITIVE (REVERSE POLARITY).
MARK REF.
1 54312029
9 53112219
11 259040
12 54312560
16 1704V10
3.4.2 MMA SYSTEM START-UP.
1) Make sure the mains voltage is 230 V.
2) Connect supply cable with the suitable plug to the relevant single-phase tap.
3) Connect electrode-holder clamp to polarity recommended by electrode manufacturer. Normally to positive pole.
4) Connect earth clamp to welding table or piece to be welded. Check correct connection of welding masses.
5) Verify that electrodes are dry. If necessary, preheat electrodes for at least one hour with oven.
REF.
54312029 Input cable
49216018 Machine-gas connection (2 m)
53112219 Earth clamp cable
37600000 Argon pressure regulator – Mod. EN 2
TIG SR 17 V torch 4m
54312560 Change of polarity cable
DESCRIPTION
Input cable
Earth clamp cable
Accessories for electrode
Change of polarity cable
Electric electrode heater
GALA 2000 MP
DESCRIPTION OBSERVATIONS
INCLUDED
INCLUDED
CONNECTED TO POSITIVE
CONNECTED TO NEGATIVE
NOT CONNECTED
16
OBSERVATIONS
INCLUDED
CONNECTED TO NEGATIVE
300A-35/50 (CONNECTED TO POSITIVE)
NOT CONNECTED
See section 2.2.
21