3.5. TIG WELDING. INSTALLATION, START-UP AND OPERATING CONTROLS.
Depending on whether the installation is cooled or not, we must set the equipment during the first start-up.
AUTOMATIC COOLING : Working mode with cooled torch.
The cooling only works in welding mode and will switch off automatically 2 minutes after carrying out the welding
process.
COOLING "ON" : Working mode with cooled torch.
The cooling works permanently after the first welding process starts.
COOLING "OFF" : It enables to work with torches without water cooling.
The cooling is deactivated, the protection against lack of water pressure is disabled.
Setting parameters adjustment system for (automatic) colled installation :
P1: SELECT THE
PROCESS
PULSE
3.5.1. TIG SYSTEM INSTALLATION. TORCH TO NEGATIVE POLE.
1
MARK
REF.
1
INCLUDED
5
INCLUDED
6
376.00.000 Argon pressure regulator – Mod. EN 2
6
379.00.000 Argon-CO
9
INCLUDED
10
190.52.634 Torch MAXIMA TIG XT-26E Euro (4 m)
GALA INVERMIG SYNER 230 MP Bi-PULSE
P1: ENTER/EXIT TO
PARAMETERS
SETTING MODE
SETTING
PARAMETERS
6
5
2
Input cable 3x4 mm
Machine-gas connection (2 m) / coupling
pressure regulator GASFREE
2
Earth clamp cable
E1: SELECT CYCLE
PARAMETER
D2:
10
4
3
DESCRIPTION
2
-3 m. (Plug not incl.)
E2: ADJUST VALUE
D3:
5
9
OBSERVATIONS
Gas saving (up to 50%)
"Euro" connection (4 m)
60
P1: SAVE
PARAMETERS
SAVED
PARAMETERS