dirna Bergstrom bycool COMPACT 3.0 Instrucciones De Montaje página 24

COMPACT 3.0
EN
Place console and centre equipment in the
12
most convenient place of cabin roof. Once
centred, remove console for later installation.
12
Fasten supports tightening nuts until outside
13
EPDM joint of equipment is compressed,
between 3 and 6 mm.
Important: To avoid water from filtering inside
cabin, check EPDM joint tightening with unit
base, as indicated on diagram.
3-6mm.
Cabin roof
Fasten selflocked nut until
EPDM gasket is
compressed between
13
3 and 6 mm.
Tighten (4) M8 nuts to support and (4) to Unit
14
base.
EPDM gasket
10 mm*
(*) (approx. after tightening)
12
Base
Bracket
24
Air conditioning for vehicles
Check compression
thickness using a
tape measure in the
four corners.
EPDM gasket
13
14