Cleaning Function; Troubleshooting; Cleaning When The Hob Is Cold - Electrolux EQT4520BOZ Manual De Instrucciones

14 www.electrolux.com
WARNING!
Sharp objects and abrasive
cleaning agents will damage
the appliance.

6.2 Cleaning function

1. Touch
The display flashes until the
temperature is 80°C. The function
locks the control panel, but not
2. When the temperature reaches 80°C
an acoustic signal sounds, and the
control panel becomes unlocked.
3. Put ice cubes one by one on the
roasting zone (you can use also cold
water). At the same time, use a

7. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
7.1 What to do if...
Problem
You cannot activate or op-
erate the hob.
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactiva-
ted.
. Each zone is set to 80°C.
Possible cause
The hob is not connected
to an electrical supply or it
is connected incorrectly.
The fuse is released.
You touched 2 or more
sensor fields at the same
time.
There is water or fat stains
on the control panel.
You put something on one
or more sensor fields.
spatula to remove the remaining
roasting pieces and push all pieces
into the trough.
4. Dry the hob with a clean cloth.
6.3 Cleaning when the hob is
cold
1. Apply a usual cleaning agent to the
roasting surface and let it set for 5
minutes.
2. Remove the cooking residue with a
.
spatula.
3. Clean the hob with a moist cloth.
4. Dry the hob with a clean cloth.
5. When the hob is dry, rub the roasting
surface with some cooking oil.
Remedy
Check if the hob is correctly
connected to the electrical
supply. Refer to the con-
nection diagram.
Make sure that the fuse is
the cause of the malfunc-
tion. If the fuse releases
again and again, contact a
qualified electrician.
Activate the hob again and
set the heat setting in less
than 10 seconds.
Touch only one sensor field.
Clean the control panel.
Remove the object from the
sensor fields.