The Heat Setting; Bridge Function - Electrolux EQT4520BOZ Manual De Instrucciones

deactivates. Remove the object or
clean the control panel.
• You do not deactivate a roasting zone
or change the temperature. After 90
minutes comes on and the hob
deactivates. Before next use, set the
roasting zone to

4.3 The heat setting

To set or change the heat setting:
Touch the control bar at the correct heat
setting or move your finger along the
control bar until you reach the correct heat
setting.
The display flashes until the roasting zone
reaches the temperature. Then a signal
sounds and the display shows the
temperature.

4.4 Bridge function

This function connects two roasting zones
and they operate as one. This function is
active automatically when you activate the
hob.
To deactivate the function: touch
The roasting zones operate independently.
4.5 Timer
Count Down Timer
You can use this function to set how long
the roasting zone should operate for a
single cooking session.
First set the roasting zone then set
the function. The selection of the Timer
function is possible for roasting zones that
are active and after the temperature is set.
To set the roasting zone: touch
again and again until the indicator of a
.
.
necessary roasting zone comes on. When
this function is active,
To activate the function: touch
the timer to set the time (00 - 99 minutes).
When the indicator of the roasting zone
starts to flash slowly the time counts
down.
To see the remaining time: set the
roasting zone with
roasting zone starts to flash quickly. The
display shows the remaining time.
To change the time: set the roasting
zone with . Touch
To deactivate the function: set the
roasting zone with
remaining time counts back to 00. The
indicator of the roasting zone goes out.
When the time comes to an
end, the sound operates and
00 flashes. The roasting zone
deactivates.
To stop the sound: touch
CountUp Timer (The count up
timer)
You can use this function to monitor how
long the roasting zone operates.
To set the roasting zone (if more than
1 roasting zone operates): touch
again and again until the indicator of a
necessary roasting zone comes on. When
this function is active,
To activate the function: touch
symbol goes out and
To see how long the roasting zone
operates: set the roasting zone with
The indicator of the roasting zone starts to
flash quickly. The display shows how long
the zone operates. During the first minute
the display shows the time in seconds.
After the first minute the display shows the
time in minutes.
To deactivate the function: set the
roasting zone with
symbol goes out and
ENGLISH
comes on.
of
. The indicator of the
or .
and touch . The
.
comes on.
. The
comes on.
.
and touch . The
comes on.
9