Technical Information; Rating Plate; Roasting Zones Specification - Electrolux EQT4520BOZ Manual De Instrucciones

18 www.electrolux.com
Assembly
1. Calculate correct cutout dimensions.
2. Prepare cutout in the worktop.
3. One by one place the hobs on a soft
surface (for example on a blanket) with
the bottom side up.
4. Attach the supplied seal stripe to the
lower edge of the hob along the outer
edge of the glass ceramic.
5. Loosely screw the fixing plates into the
correct holes in the protective casing.
6. Insert first hob into the worktop
cutout. Than insert the connection bar
into the worktop cutout. Push it half of
its width under the hob.
7. Loosely screw in the fixing plates from
below to the worktop and to the
connection bar.

9. TECHNICAL INFORMATION

9.1 Rating plate

Modell EQT4520BOZ
Typ 55 TEP 02 AO
Ser.Nr. .................
ELECTROLUX

9.2 Roasting zones specification

Roasting zone
Front
Rear
8. Insert next hob into the worktop
cutout. Make sure that the front edges
of the hobs are on the same level.
9. Tighten the fixing plates / retaining grip
screws.
10. Use silicone to seal the gaps between
the hobs and between the hobs and
the worktop.
11. Put some soapy water on the silicone.
12. Press the rubber shape with some
strength against the glass ceramic and
move it slowly along the space.
13. Do not touch the silicone until it
becomes hard, it can last about a day.
14. Carefully remove the silicone that
came out with a shaving blade.
15. Clean the glass surface.
PNC 941 460 015 00
220 - 240 V 50 - 60 Hz
1.8 kW
Nominal power (maximum heat set-
ting) [W]
900
900