SICE PT 230 E STD Manual De Instrucciones página 28

- remove the bead depressor roller, position
the bead depressor block so it is opposite the
mounting/demounting tool, press the down lever
so the bead fits inside the rim well (fig.15).
- Load the bead above the mounting/demounting
tool, move the bead depressor block away, press
the rotation pedal and remove the first bead
(fig.16).
- Move the bottom bead up to the top edge
of the rim; in some cases, even if the bead
has already been broken, the bottom bead will
remain in place because it has stuck to the
rim. In these cases, use the disc by inserting it
between the bottom bead and the rim (fig.17),
press the rotation pedal and lift.
28
WDK
14
17
The second bead can be demounted in the
traditional way, with the lever or using the bead
depressor roller.
- Position the roller tangent to the outside edge of
the rim (fig. 18).
15
- Lift the roller until it juts out from the top edge.
PT 230 E - Operator's manual + spare parts
WDK
WDK
16
WDK
18