Use; Tyre Demounting/Mounting - SICE PT 230 E STD Manual De Instrucciones

UsE

TYRE DEMoUnTInG/MoUnTInG

WaRnInG
for all tyre mounting/demounting procedures
not specifically described, refer to the tyre
changer use and maintenance manual.
HELP is designed to facilitate the demounting
and mounting stages of the light alloy rims and
particularly stiff low-profile tyres.
Proceed as follows to get the best performance
from these accessories. Proceed with bead breaking
the tyre as described in the instruction manual
enclosed with the tyre changer.
Demounting
- After breaking the bead of the wheel place it on
the turntable and clamp it on the outside.
PT 230 E - Operator's manual + spare parts
- Fit the rim clamping cone on the end of the
articulated arms, align the cone with the hole in
the centre of the rim and press the down lever
(fig.11) until the sliding clamps are inserted
between the rim and tyre (fig.12), then press the
pedal to clamp the wheel.
- Remove the centring cone, put it away and
remount the bead presser block.
- Tilt the column forwards and position the
mounting/demounting tool.
- Align the rim clamping roller tangent to the
outside diameter of the rim, press the descent
lever (fig. 13) until there is enough room
between the mounting/demounting tool and the
tyre in which to insert the bead lifter lever (fig.
14).
11
12
13
WDK
27
UK