Peg-Perego Venezia Instrucciones De Uso página 15

push the brake levers on the wheels downwards
with your foot, as shown in the figure. Always set
the brake when the stroller is not moving.
SAFETY BELT
9• A: Make sure that the brace is properly inserted by
pushing as shown in the figure. B: Fasten the belt
as shown in the figure.
10• To unfasten the belt, press on the buckle sides
and pull out the waist strap.
11• The new safety belt is now easier to fasten thanks
to the "snap-open-and-shut" device. Before
fastening the safety belt, attach the buckle to the
backrest by inserting the tab through the special
holder, as shown in the figure. After fastening
the safety belt on your child, detach it from the
backrest to allow the child more freedom of
movement. The buckle must remain below the
child's shoulders.
ADJUSTING THE BACKREST
12• The backrest reclines to three different positions.
To lower the backrest, lift the handlebar and fix
the backrest in the desired position. To raise the
backrest, pull it upwards.
ADJUSTING THE FOOTREST
13• The footrest can be adjusted to two positions.
To lower it, pull the two levers downwards while
lowering the footrest, as shown in the figure. To
raise the footrest, lift it upwards until it clicks into
place.
SWIVELING WHEELS
14• Since the stroller handlebar is reversible, all four
of the stroller wheels can be set to swivel. It is
necessary to swivel only the wheels that are on the
opposite side of the stroller from the handlebar.
Lift the lever as shown in the figure to allow the
wheels to swivel. Lower the lever for fixed wheels.
FRONT BAR
15• The front bar can be extended to two positions.
To extend it to the first position, pull the two
little levers under the front bar and the front bar
towards you, until you hear the first click. To
extend the front bar to the second position, pull
the two levers and the front bar towards you again
until you hear the second click.
16• When your children are bigger, you can remove
the front bar. To detach the bar, press the buttons
under the armrests, while pulling the front bar
out.
"CHILD TRAY"
17• To hook the child tray to the stroller, extend the
front bar to the second position and then hook the
tray onto it by pushing it down as shown in the
figure.
18• To remove the tray, push out the two side tabs of
the tray as you lift the tray upward. It is dangerous
to put hot drinks on the tray.
HANDLEBAR
19• To reverse the handlebar, simultaneously pull the
little levers on the handlebar upwards and move
the handlebar to the opposite position, pressing
until you hear the final click. While carrying out
this operation, be very careful not to catch your
child's hands or arms.
20• To adjust the handlebar height, press the side
buttons simultaneously, as shown in the figure,
and lock the handlebar into the desired position.
DRINK-HOLDER
21• The drink-holder attaches to both the right and
the left-hand sides of the handlebar. To attach
the drink-holder, slip the attachment onto the
handlebar, and push downwards until it clicks into
place. Do not place hot drinks in the drink-holder.
Do not place anything heavier than 1 Kg. (2.2 lbs.)
in the drink-holder.
BABY CARRIAGE AND/OR STROLLER
22• A) BABY CARRIAGE: Venezia becomes a baby
carriage when the backrest is lowered to the last
position, with the footrest raised, the handlebar
positioned opposite the backrest, and the wheels
on the same side as the backrest set to swivel.
• B) STROLLER: Venezia becomes a stroller when
the backrest is raised, with the footrest lowered,
the handlebar positioned on the same side as the
backrest, and the wheels opposite the backrest set
to swivel.
HOOD
23• To attach the hood, insert the tabs into the special
notches on the stroller armrests as shown in the
figure, and fasten the hood to the back of the
backrest.
24• Fasten the hood to the inner sides of the armrests,
stretch out the hood, and press down on the side
braces as shown in the figure.
25• To turn the hood into a canopy to shield the child
from the sun, open the zipper as shown in the
figure and undo the rest of the hood.
COVER
• To transform Uno into the carriage version, first
extend the front bar to the second position and
lift the footrest
26• Slip off the lower part of the hood from under the
footrest sack.
27• Insert the tabs on the lower part of the cover into
the slots in the front bar. (The slots on the front
bar flip out when the front bar is extended. If the
slots slide back into their housing, pull the two
little levers under the front bar towards you.)
28• Insert the side eyelets into the armrests.
29• Baby carriage without cover.
30• Zip the upper part of the cover to the lower part
and button to the armrests as indicated in the
figure.
31• Carriage version with cover.
CLOSING THE STROLLER
Before closing the stroller, check to make sure
that the handlebar is positioned on the same side
as backrest. If the hood is attached, pull the side
braces upwards. Make sure the four wheels are
fixed.
32• To close the stroller, lower the right-hand lever
(marked "1") until it clicks into place.
33• Lower the left-hand lever (marked "2"), and lift the
handlebar upwards.
34• Lower the handlebar to finish closing the stroller,
and close the catches as shown in the figure.
TRANSPORT
35• The stroller has a handle on each side, which
together allow you to transport it when open (as
when going down stairs) or closed.
REMOVABLE LINING
36• To remove the lining from the stroller, remove the
flaps on the sack from the armrests and unfasten
the buttons.
37• Remove the sack flap from the backrest.
38• Pull the safety belt out from under the seat.
39• Loosen the safety belt from both sides, and slip
the sack off the stroller.
40• To wash the part below the cover, undo
attachments from fittings found on the footrest
chassis as indicated in the figure.