Putting Into Operation - WAGNER G 15 Instrucciones De Uso

7. Filter insert
Pull trigger guard (1) firmly forward. Screw off
handle (4). Insert a suitable filter insert (2) with the
longer taper into the gun housing, The compres-
sion spring (3) is housed in the handle where it is
safe against loss. Screw on handle.
Filter Application Filter Mesh no.
insert type
Order no.
0034 383* Stains, glosses, super 180
0097 022** clear coats, fine
synthetic resin
paints
0043 235* Undercoats, base fine 100
0097 023** coats, fillers,
marking paints,
primers
0034 377* Emulsions, me- 50
0097 024** latex paints, dium
acrylic paints
0089 323* Filling paints, coarse 30
0097 025** large-surface
coatings
10
g

8. Putting into operation

Put airless high-pressure pump into operation
according to manufacturers instructions. Set
required operating pressure. Unlock the safety
catch on the airless spray gun and pull the trigger.
To stop spraying, release the trigger.
9. Interrupting work
Important
The airless spray gun must always be made "safe"
with the safety catch if you temporarily stop work.
If the spray equipment is left unsupervised over
longer periods, or if work needs to be done on the
spray equipment, then the operating pressure
must be relieved.
10. Cleaning
Mesh Color of
size filter
After stopping work for the day, relieve the
mm
operating pressure. Unscrew spray jet touch guard
0,084 red along with the tip. Flush airless high-pressure
pump, medium hose and airless spray gun with a
suitable cleaning agent at low operating pressure.
Clean tip thoroughly with a suitable cleaning
0,140 yellow
agent, so that no coating medium residue remains.
Clean the outside of the airless spray gun
thoroughly. Lubricate safety catch and trigger with
silicon-free oil from time to time. To clean the filter
0,315 white
insert, please refer to Maintenance.
0,560 green
*1, ** 10