Bestron AVC1000R Manual Del Usuario página 22

opARAtIon - Installation
Attach the electric brush (8) by inserting the push rod
into the electric brush. Press until a
click sound is heard. Figure 2a
Insert the hand-held vacuum cleaner
according to the direction shown in
figure 2b and 2c until a click sound is heard.
Figure 2
opeRAtIon - Before first use
1. To use vacuum cleaner, press the handle rotation button (9) and
rotate the handle of push rod to unfold or bend the handle
according to the direction shown in figure 3 until a click sound is
heard.
opeRAtIon - Charging the batteries
1. Put the adapter (2) into the wall socket. The charging light (5) will now flash.
2. Allow the hand-held vacuum cleaner to charge for at least 16 hours. The adapter may become slightly
warm whilst it is charging. This is normal, and does not indicate that the appliance is defective. When
the device is fully charged, the indicator light will stop flashing and go back to normal burning.
3. Remove the adapter plug from the mains socket. The light goes out.
opeRAtIon - use for push-rod vacuum cleaner
Put the vacuum cleaner on the floor, press the switch button (4) on the hand-held vacuum cleaner to the
"1" position, the indicator light of the brush (7) is illuminated. Press the switch button to the "0" position to
stop the appliance, the corresponding indicator light goes out.
opeRAtIon - use of hand-held vacuum cleaner
To use handheld vacuum cleaner, remove it from push rod
assembly by pressing the release button (3), and then press the
switch button again to start the hand-held vacuum cleaner.
Attach crevice nozzle to hand-held vacuum cleaner
You can use the appliance with or without the small brush
user's instructions
22
Figure 3
Figure 4