Safety Devices; Important; Safety And Information Signs - Blanco BC CH 4200 Manual De Uso

Although the appliance is complete with all safety
devices, during
additional devices must be added if necessary to
comply with the relevant legal requirements.
A)Heat sensor: a heat sensor which cuts off
operation of the front of the plate if components
overheat. Once the cause of the problem has
stopped and
decreased, operation is automatically restored.

Important

There are no indicator devices to signal
that the thermostat has been tripped.
B)Heat sensor: each heating element is equipped
with this device, which reduces its power output
in case of overheating. Once the problem has
been resolved and the temperature has
returned
automatically restored.
The illustration shows the position of the signs pro-
vided.
A)Nameplate with manufacturer and appliance
IT IT
data.
B)Burn hazard: watch out for hot surfaces.
GB GB
C)General hazard: when washing the appliance do
not point pressurised water jets at it..
D)General hazard: read the manual carefully be-
DE DE
fore carrying out any procedure.
E)General hazard: all relevant regulations must be
FR FR
complied with. "Install in compliance with the rel-
evant regulations and use in well ventilated
ES
ES
premises only".
F) General hazard: all relevant regulations must be
complied with. "No liability is accepted in case of
failure to comply with the installation and com-
missioning instructions".
G)CE marking: indicates that the appliance is com-
pliant with the relevant norms.
H)WEEE symbol: indicates that the appliance is
subject to specific waste disposal regulations.
L) Warning: Dangerous voltage
English

SAFETY DEVICES

installation and connection
the plate temperature
to normal, operation

SAFETY AND INFORMATION SIGNS

A
has
Important
There are no indicator devices to signal
that the heat sensor has been tripped.
C) Heat sensor: a heat sensor installed on the con-
trolling circuit board which cuts off the mains
power supply if the board overheats. Once the
cause of the problem has stopped and the tem-
perature has decreased, operation is automati-
cally restored.
is
Important
There are no indicator devices to signal that
the heat sensor has been tripped.
- 4 -