TRAPP JK-500 Manual De Instrucciones página 59

www.trapp.com.br
Models: JK-500/700 and JK-500/700G come from
the factory with the belts aligned and tightened. If
necessary to change or align the belts, proceed as
follows:
JK-500/700
Release screw (1) and washers (2) and (4) and nut (3),

then, remove the cover (5).
Items nut (3) and screw (4) are inside the cover.

Before mounting the cover, check the alignment of

the belts (6), then, ensure the screws are well
tightened.
Figure 3
Belt Alignment and Change
Image for illustration
purposes only
3
3
4
5
2
1
6
JK-500/700G
Release screw (1) and washer (2) and cover nut (3)

and remove the cover. Before mounting the cover,
check the alignment of the belts (4), then, ensure the
screws are well tightened.
Figure 4
Image for illustration
purposes only
2
4
1
3
59