Useful Suggestions - TRAPP JK-500 Manual De Instrucciones

Throghout the use of the equipment situations and or problems may occur, for which we present some
suggestions:
Trouble
Equipment
jammed
Low
production
Irregular
chopping
Difficulty
starting motor
66

Useful Suggestions

Probable cause
Excess feeding or overload.
Due to this motor cannot achieve
required rotation, and the material
accumulates in the
(continuous use under
condition, can cause
burn-out due to overload).
1. Insufficient feeding of the
shredder.
2. Motor rotation lower than
specified.
3. Moist or green produce.
4. Adjustment on shredder is not
consistent with the material in
use.
1. Dull cutting blades.
2. Worn or unbalanced.
1. Excess or overload of produce.
2. Drop of high tension or
power source.
Solution
Turn OFF shredder immediately and wait for motor to
stop. Open hatch and remove the excess material inside
shredder, close hatch. Once shredder is ready to
shredder operate, turn ON the motor, and wait until rotation
this reaches its full speed, only then resume work. Maintain
motor a steady and regulated amount of input, so as not to
overload motor.
1. Maintain a continuous feeding flow, yet not
over-feeding which may cause the shredder to jam.
2. Verify if purchased motor to be installed on
shredder (shredder sold without motor) is
compatible accoding to specifications (see sticker
on shredder). If motor rotation is below
specification, the hammers will be delayed causing
low production.
3. When using funnel only grind dry grains and/or
dry produce. Grinding moist or green grains/
produce will clog and obstruct strainer.
4. Select different strainer for your choice application
(coarse or fine).
1. Sharpen cutting blades (page 63 and 64).
2. Follow procedure indicated (page 62).
1. Turn OFF equipment immediately and wait for
motor to stop. Open hatch and remove the excess
material inside equipment, close hatch. Once
equipment is ready to operate, turn ON the motor,
and wait until rotation reaches its full speed, only
then resume work.
2. Consult electrician to check power source.
www.trapp.com.br