Working - IPC CT5 LAVAMATIC Manual De Instrucciones

Working

• Press the main switch (fig. 16, ref. 1).
• Press the brush button or the ECO button (fig. 17, ref. 1), in addition
to activating the brush, this will also enable the vacuum function
and the flow of detergent solution.
• Lower the squeegee by operating the lever (fig. 16, ref. 2).
• Depress the brush control lever (fig. 16, ref. 3).
• Begin working.
This machine can dry the floor moving both forward and in reverse.
To operate the drying function in reverse, pull the lever upwards
• When work is in progress, check the thoroughness of the wash and
regulate the flow of detergent solution accordingly, with the relative
button (fig. 17, ref. 3).
Check periodically that the detergent solution is reaching the
brush, and take care to fill the tank when empty.
Should the red Led of the battery charge indicator light up when
work is in progress, this means that the battery is almost out of
power, and after a few seconds the brush and vacuum functions will
shut off automatically. Proceed to recharge the battery, referring to
the section "Battery: preparation / installation / recharging".
In cases where floors are soiled with particularly stubborn dirt, scrubbing
and drying operations can be performed in two separate stages.
Prewashing with brushes or pads:
• Plug the machine into the power socket (mains powered model).
• Raise the squeegee by operating the lever (fig. 16, ref. 2).
• Press the main switch (fig. 16, ref. 1).
• Press the brush control button (fig. 17, ref. 1).
• Switch off the vacuum function by pressing the suction control
button (fig. 17, ref. 2).
• Depress the brush control lever (fig. 16, ref. 3).
• When scrubbing particularly dirty areas, give the detergent sufficient
time to perform its chemical action of detaching and suspending
the dirt in the film of water, and allow the brushes time to exert an
effective mechanical action.
Drying
• Lower the squeegee by operating the lever (fig. 16, ref. 2).
• Press the suction control button to activate the vacuum function,
and pass over the area washed previously: this will produce an
effect similar to a thorough scrub, with the result that subsequent
routine maintenance work on the floor will be less time-consuming.
! INFORMATION
(fig. 18, ref. 1).
! INFORMATION
! WARNING
EN
3
2
1
Fig.16
1
3
Fig.17
1
Fig.18
18
2