Distributor Roller Adjustment; Feeler Adjustment; Seed Agitator Shaft - Maschio GASPARDO COMPAGNA 1300 Empleo Y Mantenimiento

ENGLISH
4.4.2 DISTRIBOTOR ROLLER ADJUSTMENT
B
The most appropriate type of seed distributor roller must be selected
prior to sowing on the basis of the type of seed being drilled (H,
Fig. 23). The machine is fi tted with rollers for small, medium and
large seeds. Select the type of distributing roller according to the
information given in Table 4. Which is selected by inserting the
key supplied (Fig. 22) into the slot on the left side of the roller and
push the drag retainer all the way out. Perform the a.m. operation
in inverse order to retum the roller to its initial position.

4.4.3 FEELER ADJUSTMENT

C
The feeler adjustment lever (Fig. 24) is positioned on the left side
of the machine and works according to a graduated scale that runs
from 0 - 9 settings. The lever must be set to the number indicated
by the sowing table on the basis of the type of seed to be sown.
If the feelers (I, Fig. 23) are correctly positioned, they assure a fl uid
and constant distribution of the seeds.
The lever positioned beyond the maximum opening, causes
the discharge of the seeds from the hopper.
For best seeding results, periodically check the position of the feeler
pins (I): adjust the distance between the feeler and the distributor
roller (H) by means of the nut (M) to 0,5 ÷ 1 mm (Fig. 23).

4.4.4 SEED AGITATOR SHAFT

D
The seed agitator shaft can be connected (POS.1 Table 4) or
disconnected (POS.2 Table
Remember that when sowing large seed (peas, soy beans,
etc.), it is advisable to disconnect the seed agitator shaft
from the transmission (Fig. 25) to avoid damage to the seed
itself.
66
USE AND MAINTENANCE
ATTENTION
4).
fi g. 22
L
H
M
fi g. 23
fi g. 24
9
0
fi g. 25
I
fi g. 37
cod. F07010993