Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
GB
Installation Instructions
Electrical system for extending 13-pin electrical installation sets
from Westfalia
Adds continuous positive, charging wire and earthing functions
Volkswagen AG Part number:
Volkswagen UK Part number:
Westfalia Order No.:
Area of Application:
General Information:
Before starting work, please read the installation instructions.
The holes drilled must be deburred and then coated with anti-corrosion paint.
The electrical set may only be installed by specially-trained personnel with the battery disconnected.
Please make sure before drilling that there is sufficient clearance behind the trim.
Important: Any electronically stored data (car radio, onboard computer etc.) may be lost.
Duraseal Methodology
• Cut the wires intended for connection and strip back the insulation by 10mm.
• Twist the exposed cable, (where two wires enter the Duraseal Connector at the same end twist
the cable together) and trim surplus to leave 6mm of exposed cable.
• Place a Duraseal connector in an approved crimping tool and insert the intended wire(s) into
one end, apply pressure to the crimps and maintain the pressure for approximately 5 seconds
after the jaws have closed.
• Repeat the process at the opposite end of the Duraseal Connector.
• Using the Hot Air Blower 1978/14 and Shrink Element 1978/15, heat the Duraseal Connector
until the sleeve seals at both ends of the connector.
The German version of these installation instructions shall be applicable in event of any legal
questions.
Subject to modification!
14
3C0 055 204 B
ZGB 000 055 200 B
ZGB 000 055 200 W
321 025 300 113
300 025 300 113
Extension for 13-pin Westfalia electrical systems
Publicidad
Tabla de contenido
