Fm Radio Operation - Lenco PMX-160BK Manual Del Usuario

When the display is showing Source B group status, letter "B" will be displayed as shown below.
Press the [MODE] button to select different sources. Source B group includes:
• USB B
• BT B
• LINE IN
To toggle between Source A group and Source B group, press the [SOURCE A/B] button or long press the [A/B/100+] button on the
remote control.
Master Volume Control (16)
Turn the [- VOLUME +] knob on the unit to change the master volume.
In addition press remote control VOL +/- button to further adjust the A and B source volume level. For example when you select
source A with "A" displayed, press the remote control VOL +/- buttons to change the source A sound level. Or when you change to
source B with "B" displayed, press the remote control VOL +/- buttons will change the source B sound level.
DJ Mixing Relative Volume Control
Turn the unit's DJ MIXER LEVEL knob(2) to change the audio source A and B DJ mixing level
Alternatively you can press remote control VOL -/VOL + buttons to individually change the source A and source B volume level. For
example when you select source A with "A" displayed, press the remote control VOL -/+ buttons to change the source A sound level.
Or when you change to source B with "B" displayed, press the remote control VOL -/+ buttons will change the source B sound level.
NOTE: The mastervolume setting of (16) is the max. volume of the A and B source!
Speaker Lighting and Floor Lighting ON/OFF
Press the [ ] button (or press and hold the [0/ ] button on the remote control) to turn on the lighting. To turn off, press the button
again.
Note: In order to ensure the best FM reception, the speaker and floor lighting will automatically be turn off when the FM mode is
selected. Pressing the [
Adjusting the Antenna
The antenna wire at the top panel of the unit should be unwind, extended and altered to ensure a good FM reception.

FM RADIO OPERATION

Turn on the unit and press [MODE] button until it is in FM mode (a small FM symbol will be lit on the display). The FM antenna wire
at the unit's rear panel should be extended and altered to ensure a good FM reception.
Manual search FM frequencies
Longpress the [A PREVIOUS
Shortpress the [A PREVIOUS
Auto Scan (5)
Press and hold the [SCAN] button to start auto-scanning and saving the available stations
Recall FM Presets
Press the [A PREVIOUS
] button (or press and hold the [0/
] (4) or [A NEXT ] (6) to scan to the next station found
] (4) or [A NEXT
] or [A NEXT ] to tune to different preset channel.
] button on the remote control) will have no function.
] (6) to fine tune
10