Basic Operation - Lenco PMX-160BK Manual Del Usuario

To replace a new battery, please refer to the figure shown below. When inserting a battery, be sure to do so in the proper direction.
• If the remote control conflicts with other devices, the operation will be affected.
• Do not simultaneously press buttons on the unit and the remote control.
• Avoid using two remote controls at the same time as it will cause a malfunction.
• Use only CR-2025 size batteries.
• If there is battery leakage, clean the remote control thoroughly before replacing batteries.
• Do not short two terminals of the batteries. Dispose old batteries in a suitable place.

BASIC OPERATION

To turn on the unit, set the POWER switch on the rear panel to the ON position. The display will be turned on.
To turn off the unit, set the POWER switch to the OFF "O" position.
Source Selection
When the display is showing Source A group status, letter "A" will be displayed as shown below.
Press the [MODE] button to select different sources. Source A group includes:
• FM
• USB A
• MICRO SD
• BT A
Battery case
Push in according to this direction
Pull out the battery case
CR2025 battery
9